Plinius-audio Anniversary Integrated Amplifier User Manual download pdf (Page 18)

17INTEGRAT E D AMPLIFI E R

Product Features

REMOTE CONTROL

Provided with your Anniversary Integrated Amplifier is a 16 function remote control.

Two AAA batteries power the remote, and these are replaced by removing the two

screws on the base of the remote that hold the battery compartment in place. The

bottom end of the remote is now free to slide out for access to the batteries. Replace

the two batteries, taking care to refit the new ones with correct polarity.

PHONO GAIN ADJUSTMENT

The phono stage can also be set to high or low gain to suit your phono turntable

specifications (high gain is the factory setting). Disconnect the lead from the IEC

socket on your Anniversary Integrated Amplifier and make sure the Mains switch is

OFF. Carefully remove the lid by undoing the cap screws on the top. Locate the

small black phono jumpers to the middle-right side of the top circuit board. The gain

can now be adjusted noting that high gain (factory setting) is set with jumpers to the

left, and low gain is set with jumpers to the right. Now re-assemble your Anniversary

Integrated Amplifier.

FUSE PROTECTION

When any rail fuse is damaged one or more fuse warning LED’s will light. These LED’s

are located next to the fuse that has blown. To replace the fuse, disconnect the

ampliﬁer from the mains power and wait 30 minutes, then ﬁrmly push in the round fuse

cap with your ﬁngers. When the cap cannot push in any further, rotate the cap anti-

clockwise (to the left) until it comes to a stop. Release inward pressure on the fuse cap

and it can now be removed from the ampliﬁer. Replace them with the same type only.

To re-ﬁt the fuse, insert the fuse and gently turn it as far as possible anti-clockwise (to

the left). Now push the fuse cap in ﬁrmly, then turn clockwise (to the right) until it comes

to a stop. Release inward pressure on the cap and the fuse will be ﬁtted securely.

IMPORTANT: DO NOT FIT A FUSE WITH A HIGHER RATING.

NOTE: that fuse failure may indicate a severe problem. Check all speakers and

speaker cables for damage etc. Should the amplifier continue to exhibit rail fuse

failure, contact your Plinius dealer.

MAINS/LINE FUSE

A Mains/Line fuse is fitted within the IEC socket on the rear of the amplifier. A small

drawer at the bottom of this socket may be removed (after the IEC plug is removed)

by levering it out with a flat blade screwdriver. The fuse fitted should be rated as

specified on the rear panel.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23

No comments

Plinius-audio Anniversary Integrated Amplifier User Manual Page 18